Controler Interface Devices

All the Disys Technologies nodes are micro-controller based intelligent devices which monitor the status of other elements of the damper control system and broadcast status information to the network.

DIN 12

The DIN 12 is most commonly used as the fire/smoke damper control node. Available to control either 230V ac or 24V ac/dc actuators, it also monitors the status of the actuator limit switches.

DIN 08F

The DIN 08F provides 8 opto isolated zone alarm inputs to the damper control system from fire alarm system relay outputs.

DIN 24A

This variant is most commonly used as an interface between the damper control system and AHU’s. It provides the facility to shutdown the AHU in the event of a fire and then to override it via the fireman’s override switches.

DIN 08M

The Din 08M provides 8 opto isolated damper position monitoring inputs. Each damper normally produces an open and a closed signal. The DIN 08M is used to monitor up to 4 Dampers.

LNI

The LNI or Loop Network Inegrator is designed to allow many loops (Restricted to 125 devices) to communicate over a master loop to the TUI. This increase the ammount of devices that can be connected to the TUI whilst maintaining communication speed and reliabuility.

DIN 80

The DIN80 provides 8 binary volt free outputs. this can be used to switch low power devices eg relays, laps etc.

© Copyright 2021 - Disys Technologies Ltd - Disys is a registered trademark of Disys Technologies Ltd - Company registered in England & Wales No 4226796