Controller Interface Devices


All the Disys Technologies controller interface devices are micro-controller based intelligent devices which monitor the status of various elements of the damper control system and broadcast status information to the network.

FireSmart MC1N

The MC1 Node is the interface for a single 24V fire/smoke damper.
It provides control and position monitoring of both spring return and power closed actuators, and reports the damper status to the MC1 Panel.

DIN 12

The DIN 12 is most commonly used as the fire/smoke damper control node. Available to control either 230V ac or 24V ac/dc actuators, it also monitors the status of the actuator limit switches.

Datasheets:

DIN 08

The DIN 08 come in 2 variants, the DIN08F provides 8 opto-isolated zone alarm inputs to the damper control system from fire alarm system relay outputs. The DIN 08M provides 8 opto-isolated damper position monitoring inputs. Each damper normally produces an open and a closed signal. The DIN 08M is used to monitor up to 4 Dampers.

Datasheet:

DIN 24A

This variant is most commonly used as an interface between the damper control system and AHU’s. It provides the facility to shutdown the AHU in the event of a fire and then to override it via the fireman’s override switches.

LNI

The LNI or Loop Network Integrator is designed to allow multiple loops (each loop restricted to 125 devices) to communicate over a master loop to the TUI control panel. This increases the amount of devices that can be connected to the TUI whilst maintaining communication speed and reliability.

Datasheet:

DIN 80

The DIN80 provides the damper control system with 8 binary volt free outputs that can be used to switch low power devices such as relays.

Datasheet:

© Copyright 2026 - Disys is a registered trademark of Disys Technologies Ltd - Company registered in England & Wales No 4226796 - Privacy Statement